Catalyst 4006 & Error

[weldpua2008 0]

Неприятное сообщение - что оно означает?

WS-X4124-FX-MT revision - это хардваре или софтваре несовместимость?

 

 

00:00:15: %C4K_SUPERVISOR-3-OLDWSX4124: WS-X4124-FX-MT revision 1.5, which is <

1.6, is not supported

 

Switch#show module

IOS Catalyst 4000 L3 Switch Software (cat4000-I5K91S-M), Version 12.2(20)EW

A, RELEASE SOFTWARE (fc1)

....

Chassis Type : WS-C4006

 

Power consumed by backplane : 0 Watts

 

Mod Ports Card Type Model Serial No.

---+-----+--------------------------------------+------------------+-----------

1 2 1000BaseX (GBIC) Supervisor(active) WS-X4014 JAB061106YV

 

3 0 Unsupported module WS-X4124-FX-MT JAB041409VZ

 

 

M MAC addresses Hw Fw Sw Status

--+--------------------------------+---+------------+----------------+---------

1 0007.0ec2.c800 to 0007.0ec2.c801 1.2 12.1(11br)EW 12.2(20)EWA Ok

3 0001.425c.fbc8 to 0001.425c.fbdf 1.5 Unsupport

 

Загружал эти прошивки-не помогло:

boot tftp://10.1.1.1/cat4000-is-mz.121-8a.EW1.bin

boot tftp://10.1.1.1/cat4000-is-mz.121-13.EW.bin

boot tftp://10.1.1.1/cat4000-i4s-mz.122-20.EW.bin

boot tftp://10.1.1.1/cat4000-i5k91s-mz.122-25.EWA14.bin

boot tftp://10.1.1.1/cat4000-i5s-mz.122-25.EWA14.bin

boot tftp://10.1.1.1/cat4000-i5su3-mz.122-20.EU2.bin

boot tftp://10.1.1.1/cat4000-i9k91s-mz.122-25.EWA6.bin

boot tftp://10.1.1.1/cat4000-i9s-mz.122-25.EWA14.bin

boot tftp://10.1.1.1/cat4000-is-mz.121-8a.EW1.bin

boot tftp://10.1.1.1/cat4000-is-mz.121-13.EW.bin

 

Нашел

Error Message C4K_SUPERVISOR-3-OLDWSX4124:WS-X4124-FX-MT revision [dec].[dec],

which is < 1.6, is not supported

 

Explanation This message indicates that the WS-X4124-FX-MT modules with hardware revisions 1.6 or earlier are not supported.

 

Recommended Action Replace this module with a WS-X4124-FX-MT module revision 1.7 or later.