Extreme & Loopback Detection

[weldpua2008 0]

Вопрос - только у Меня на extreme-ах summit 200 не работает loopback detection?

Делаю:

#summit 200-24

enable lbdetect ports 1-24

не работает loopback detection

firmware: 7.7.3, 8.2.1

 

Loopback Detection

Each port may enable loop detection. This optional feature detects that a port has been looped back to

the local system. If a loopback is detected, the port is disabled. Note that loopbacks may exist between

different ports. The feature will disable any port that both has the feature enabled, and receives an

LACP message that was sent from the local system.

To enable or disable loopback detection, use the following commands:

enable lbdetect port <portlist> [retry-timeout<seconds>]

disable lbdetect port <portlist>

[roger 12]

а чего ты решил что не работает?