weldpua2008 0 Posted 2009-10-03 16:02:15 Share Posted 2009-10-03 16:02:15 Вопрос - только у Меня на extreme-ах summit 200 не работает loopback detection? Делаю: #summit 200-24 enable lbdetect ports 1-24 не работает loopback detection firmware: 7.7.3, 8.2.1 Loopback DetectionEach port may enable loop detection. This optional feature detects that a port has been looped back to the local system. If a loopback is detected, the port is disabled. Note that loopbacks may exist between different ports. The feature will disable any port that both has the feature enabled, and receives an LACP message that was sent from the local system. To enable or disable loopback detection, use the following commands: enable lbdetect port <portlist> [retry-timeout<seconds>] disable lbdetect port <portlist> Link to post Share on other sites
roger 12 Posted 2009-11-01 19:30:37 Share Posted 2009-11-01 19:30:37 а чего ты решил что не работает? Link to post Share on other sites
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now