CBQ-init перестал работать.

[Den_LocalNet 1 472]

Нужен хелп.

На шлюзе перестал работать сабж.

делаю service cbq list есть вывод примерно такой:

[[root@gw0 cbq]# service cbq list
### eth0: queueing disciplines

qdisc cbq 1: rate 100Mbit (bounded,isolated) prio no-transmit
qdisc tbf 1001: parent 1:1001 rate 750Kbit burst 10Kb lat 53.3ms

### eth0: traffic classes

class cbq 1:1001 parent 1: leaf 1001: rate 750Kbit (bounded) prio 1
class cbq 1: root rate 100Mbit (bounded,isolated) prio no-transmit
class tbf 1001:1 parent 1001:

### eth0: filtering rules

filter parent 1: protocol ip pref 100 u32
filter parent 1: protocol ip pref 100 u32 fh 800: ht divisor 1
filter parent 1: protocol ip pref 100 u32 fh 800::800 order 2048 key ht 800 bkt 0 flowid 1:1001
 match 0a000000/ff000000 at 12

### eth1: queueing disciplines

qdisc cbq 1: rate 100Mbit (bounded,isolated) prio no-transmit
qdisc tbf 1001: parent 1:1001 rate 750Kbit burst 10Kb lat 53.3ms

### eth1: traffic classes

class cbq 1:1001 parent 1: leaf 1001: rate 750Kbit (bounded) prio 1
class cbq 1: root rate 100Mbit (bounded,isolated) prio no-transmit
class tbf 1001:1 parent 1001:

### eth1: filtering rules

filter parent 1: protocol ip pref 100 u32
filter parent 1: protocol ip pref 100 u32 fh 800: ht divisor 1
filter parent 1: protocol ip pref 100 u32 fh 800::800 order 2048 key ht 800 bkt 0 flowid 1:1001
 match 0a000000/ff000000 at 16

 

т.е. правила добавляет.

но они не работают.....

ничего не менял вроде..... раньше всё работало.

вот конфиги:

[root@gw0 cbq]# cat interfaces
EXTERNAL_ETH=eth0
EXTERNAL_SPEED=100
INTERNAL_ETH=eth1
INTERNAL_SPEED=100

[root@gw0 cbq]# cat cbq-1001.out
DEVICE=eth1,100Mbit,10Mbit
RATE=750Kbit
WEIGHT=75Kbit
PRIO=1
RULE=10.0.0.0/8

[root@gw0 cbq]# cat cbq-1001.in
DEVICE=eth0,100Mbit,10Mbit
RATE=750Kbit
WEIGHT=75Kbit
PRIO=1
RULE=10.0.0.0/8,

[S_ergey 21]

service sbq compile потом restart

Но я перешел на htb-tools доволен больше чем cbq.