Поиск по сайту
Результаты поиска по тегам 'LACP на Cisco 3550'.
Найдено 1 результат
-
Доброго дня всем! Нужно поднять lacp между cisco 3550 и екстримом interface Port-channel1 description LACP p2+3 switchport trunk encapsulation dot1q switchport trunk allowed vlan 1416 switchport mode trunk interface GigabitEthernet0/2 description LN switchport mode dynamic desirable no cdp enable channel-protocol lacp channel-group 1 mode active И вот результат не поднялось : Switch#show interfaces port-channel 1 Port-channel1 is down, line protocol is down (notconnect) Hardware is EtherChannel, address is 0011.2196.fb82 (bia 0011.2196.fb82) Description: LACP p2+3 MTU 1546 bytes, BW 1000000 Kbit, DLY 10 usec, reliability 255/255, txload 1/255, rxload 0/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Auto-duplex, Auto-speed, media type is unknown input flow-control is off, output flow-control is off ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output 00:10:06, output hang never Last clearing of "show interface" counters never Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: fifo Output queue: 0/40 (size/max) 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 47990 packets input, 6965412 bytes, 0 no buffer Received 2 broadcasts (0 multicasts) 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 watchdog, 2 multicast, 0 pause input 0 input packets with dribble condition detected 11 packets output, 896 bytes, 0 underruns 0 output errors, 0 collisions, 1 interface resets 0 babbles, 0 late collision, 0 deferred 0 lost carrier, 0 no carrier, 0 PAUSE output 0 output buffer failures, 0 output buffers swapped out
