Jump to content

Myqsl помогите с ошибкой

Recommended Posts

Помогите разобраться поставил с нуля free bsd12.0 amd64

Ubilling залил 

Столкнулся с проблемой когда начал настраивать куча ген дошел до радиус3 и тут вот что


Edited by Ivan_pro100_5

Share this post

Link to post
Share on other sites

потому что дамп для радиуса заливаете два или больше раз, вот он на ALTER TABLE и ругается

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Similar Content

    • By ilcergio
      Hello Someone could be so kind and record a video of How to configure hotspot in mikrotik HotSpot КучаГен
      The truth is I don't want to bother you but as everyone knows I don't speak any language other than Spanish and I read everything translated and the translations are sometimes not clear, so I think a video could help me more since I have a lot of time trying to do it function and failed.
    • By Oleg2018
      При тестовой проверке в дебаг режиме вываливается pap: WARNING: Authentication will fail unless a "known good" password is available и в результате запрос игнорирует. Понимаю что не воспринимает пароль. Все делал строго по инструкции. Кто сталкивался и как решал?
    • By Optimal
      Налаштований мультиген + рррое мікротік з ось такими атрибутами radius:

      Прошу підказати чи є інший варіант скидання сесії, якщо користувач був заблокований і поповнив рахунок (тобто став активним) крім як регулярне скидання сесії блокованого користувача по session-timeout? Постійні реконекти не добавляють інформативності логу, але іншого варіанту не знайшов поки...
    • By ilcergio
      Hi me again
      I was watching the Dynamic shaper and I can't find a way to control Down speed Kbit / s / Up speed Kbit / s separately
      to be able to give Down speed Kbit / s and Up speed Kbit / s for example 512 of Down speed Kbit / s and 256 Up speed Kbit / s I would like to be able to use it with КучаГен it would be interesting if you could change rates with the Dynamic shaper and disconnect and КучаГен user connection to update or by CoA that could allow parameters to КучаГен from Dynamic shaper this would open up a wide range of possibilities
      I think that would be something that would give a lot of added value to the system and very useful
    • By ilcergio
      Hello What are the possibilities of using this configuration in КучаГен?

      What should I place here?